Exhaust For Subaru Impreza WRX STI 2003-2004 Car




The HKS Carbon-Ti catback exhausts are exclusive Special Edition HKS Hi-Power catback exhaust systems. Also referred to as the HKS Carbon Titanium Hi-Power catback exhaust, these exclusive versions of the HKS Hi-Power catback exhaust consist of a carbon-fiber wrapped muffler shell, titanium tip, and polished SUS304 stainless steel piping for a stylish and aggressive look. Each HKS Carbon-Ti catback exhaust looks as good as it performs.

Inspired by GT racing in Japan, HKS developed its Carbon-Ti catback exhaust system with features found on racing exhaust systems. The HKS Carbon-Ti catback exhaust series incorporates a race inspired offset muffler and piping design, eliminating unnecessary bends for the straightest exhaust path. This less restrictive design allows the HKS Carbon-Ti catback exhaust to have greater exhaust flow and less back-flow pressure, enhancing higher-PRM power gains.

The HKS Carbon-Ti catback exhaust system can be used for both turbocharged and naturally aspirated car applications. For turbocharged applications, the large and smooth exhaust flow allows greater exhaust velocity for better mid-range boost response and high-RPM power. Naturally aspirated vehicles also benefit from greater exhaust flow capacity as engine tuning levels increase. Certain HKS Carbon-Ti applications are available in a Silent Hi-Power version which has an inner silencer built into the muffler.

Like the HKS Hi-Power catback exhaust systems, the HKS Carbon-Ti catback exhaust systems are made from high-quality SUS304 stainless steel. Each HKS Carbon-Ti catback exhaust system features high-quality mandrel bent piping and application specific muffler assemblies.

Most HKS Carbon-Ti exhaust systems are complete catback units, which do not effect emission related hardware. Each HKS Carbon-Ti catback exhaust system is designed for a specific car application and can be bolted on out of the box, using factory mounting hangers.

Depending on the car application, certain HKS Carbon-Ti catback exhaust systems can have muffler tip size of 96mm, 115mm or 120mm in diameter and piping diameter size of 55mm to 95mm.

APPLICATION: HKS Carbon-Ti Catback Exhaust Subaru Impreza WRX STI 2003-2004

This HKS Carbon-Ti Catback Exhaust Subaru Impreza WRX STI 2003-2004 has the following features: pipe size 75mm -- tip size 120mm.

Comments

venugopal said…
Thanks for the information, we will add this story to our blog, as we have a audience in this sector that loves reading like this”

Car Exhaust Systems
12:56 PM
Post a Comment

Popular posts from this blog

Maintaining your Turbo Charged Impreza Car Engine

Image
Starting and Stopping your Engine ( including Turbo Timers) When starting the engine, do not press the throttle at the same time! The engine management system is programmed to automatically adjust the settings and if you should press the throttle during the sequence it is actually possible to cause the system to shut down with the result of a non starting car. (A couple of owners have reported a more persistent starting problem. When the dealer connected the "select monitor" to the ECU, a fault in the crank sensor was reported: a new crank sensor cured the starting problems) In order to prolong engine life, a few common sense rules should be followed when starting and stopping the engine of your Impreza. When starting the engine from cold, you should avoid hard acceleration or high revs (i.e. boost conditions on turbo cars) until the engine has fully warmed up. Most engine wear occurs within the first few minutes after starting when the engi...
Read more

IGNITION VOLT STABILIZER RAIZIN SPARK FOR WRX STI CARS

Image
BRINGS OUT 100%YOUR IGNITION COIL'S PERFORMANCE : TYPE V Until now, due to various types of load resistance and interference at the contact terminals, fuses, contact points and cords in the electric circuitry on the way to the ignition coil, major loss occurred and optimum combustion did not take place. To help solve this the Raizin Spark utilizes a new approach in voltage stabilizer devices for ignition coils that brings out 100% of your ignition's performance by providing point blank power to the ignition coil via connection to our specially designed circuitry. This in turn gives you dramatic improvement in engine performance from optimum ignition to ideal combustion. Easy-installation with couplers connected. The installation is easy and does not allow for wiring mistakes. Simply connect by inserting the supplied coupler to the standard coupler and then connect to the battery. Model Specificity ...
Read more